Introduction to the K-Series Programmable ECU

 Top  Previous  Next

The Hondata K-Series Programmable ECU consists of three components:

 

•ECU - the Honda ECU.
•KPro - a electronic board which fits inside the Honda ECU which allows the ECU to be re-programmed plus adds datalogging functions.
•KManager - Windows software which interfaces with KPro.

 

KPro I

•Sold before April 2007
•Green circuit board
•Allows re-programming of the factory ECU.
•Datalog from the ECU to a laptop via USB.

 

KPro II

•Sold between August 2007 and September 2011.
•Green circuit board
•16 MBit of onboard datalogging memory.
•10-110 minutes of recording without a laptop.
•50 Hz onboard datalogging

 

KPro III

•Sold from September 2011 to November 2014
•Red circuit board
•32 MBit of onboard datalogging memory.
•10-200 minutes of recording without a laptop.
•Improved upload speed (3 times as fast as the KPro I & II)
•8 analog inputs for datalogging.
•Digital input channel.
•Calibrations stored on KPro for quick access and improved download reliability.
•Anti-theft features: owner information stored on KPro, internet registration with Hondata, upload can be password protected.

 

KPro4

•Sold from December 2014 onwards.
•White circuit board
•64 MBit of onboard datalogging memory.
•100 Hz onboard datalogging
•10-215 minutes of recording without a laptop.
•Improved upload speed (50% faster than KPro3)
•Bluetooth
•Ethanol sensor input
•Speed sensor input
•RS232 output
•CAN output
•Flex fuel
•Dash output
•Advanced protection
•Live tuning

 

Note that KPro installation requires modification to the ECU which is not reversible.

 

Hondata, Inc.

2840 Columbia St

Torrance, CA 90503

Tel: 310-782-8278

World Wide Web Site: http://www.hondata.com

© Hondata, Inc., 2003-2014

 

Hondata is not affiliated with Honda Motor Co.  Windows is a trademark of Microsoft Corp.