Hondata

So I'm looking over my datalogs and am looking at my Manifold Pressure (MAP) which are in "/psi. Under my "Sensors > MAP" I have the display min and max set to "0" and "20" respectively.

However, when looking at my graph, although the left side of the graph shows 0 - 20 along the y axis, when my MAP gets up to 20 PSI the line is only like 20% up the y axis instead of all the way up.

Any ideas?

Change it to 0 and 1

inches and psi are 2 different units so it does not behave like other graph templates.

I had to change it to 0 and 3 because it was still going off the chart. Now I see all vacuum and 20psi filling the whole graph correctly.

note: I hope this doesn't change my display settings in the "display" area with the guages.