Page 1 of 2
red light inside the ecu
Posted: Wed Aug 12, 2009 9:16 pm
by boosted93coupe
ok i can not figure out why the red light is on inside my ecu instead of the green one....the other day one of the wires came off my map sensor and i think it might have touched one of the other wires so i dont know if that would do anything or not and i switched main relays and i checked all my grounds i dont know wut else could be wrong
Posted: Thu Aug 13, 2009 6:35 am
by kinetics
Red light is the datalogging LED, I believe.
Blinks when you're datalogging. Solid when onboard datalogging is turned on.
Posted: Thu Aug 13, 2009 10:15 am
by Spunkster
Can you still upload and datalog and is it working normally?
Posted: Thu Aug 13, 2009 10:30 am
by boosted93coupe
Spunkster wrote:Can you still upload and datalog and is it working normally?
i havent tried to datalog the red light is on even when its not plugged in.....it just all of a sudden came on without me even havin the computer plugged in
red light
Posted: Thu Aug 13, 2009 6:22 pm
by boostedpumpkin
my red light comes on while driving. i cant pin point it to a specific cause but it doesnt seem to affect how the car runs. i have checked with my laptop and has no codes. it doesnt ever come on consistantly like at vtec or full boost or anything i can figure out. this is while not datalogging.
Posted: Thu Aug 13, 2009 7:50 pm
by boosted93coupe
yea i checked today and i cant upload anything it just has an error....i can download from the ecu but not upload anything to the ecu
Posted: Fri Aug 14, 2009 9:31 am
by Spunkster
What version of software are you using from Help, About?
Posted: Fri Aug 14, 2009 11:17 am
by boosted93coupe
i just downloaded the new version and it still didnt help
Posted: Fri Aug 14, 2009 11:22 am
by Spunkster
you still have not answered the question, what version were you using?
Posted: Fri Aug 14, 2009 3:58 pm
by boosted93coupe
s300 in a p06 converted to vtec...is that wut ur talkin about by version?
Posted: Fri Aug 14, 2009 11:59 pm
by boosted93coupe
the version i am using is 1.4.2.0
Posted: Mon Aug 17, 2009 9:38 am
by Spunkster
Since you have now upgraded, please go to File, New or click on New Calibration and choose teh very first calibration. Upload that to the ecu and see if you can datalog.
Posted: Wed Aug 19, 2009 7:21 pm
by boosted93coupe
i tried that and it wont upload the new calibration to the ecu
Posted: Thu Aug 20, 2009 12:14 pm
by Spunkster
Please email support at hondata.com to obtain an RMA number and include a link to this thread.
Posted: Fri Aug 21, 2009 5:38 am
by boosted93coupe
whats there email address?