Hondata

In the new version, the injector sizing wouldn't change if I saved the calibration and exited

Tried all kinds of tricks and it still wouldnt save until I had to edit the calibration code in notepad.

I have tested this and I'm not able to reproduce the problem. What type of claibration are you using?

A variety of calibrations of all types and setups, they all do the same.

I seem to have "fixed" the problem..I need to click save multiple times before it will stick.

EDIT: Also I need to keep the parameters window open, or it won't save at all, so try closing the parameters table before trying to replicate the problem

I still cannot reproduce this.