GM 3 bar map sensor
Posted: Tue Sep 17, 2002 10:08 pm
Well i have the GM 3 bar map sensor and i have a little bit of a wiring problem with it... On the hondata installation manual it says:
GM code Honda wire color
A green/white
B white
C Yellow/Red
However my wires for my stock map sensor are:
Red/white
Blue/White
White/Blue
I dont have a multi-meter to measure voltage right now, so does anyone know how i can run it without having to go into hondalogger to datalog the voltage? This is going on an obd1 h23a motor with hondata 4b. Thanks.
GM code Honda wire color
A green/white
B white
C Yellow/Red
However my wires for my stock map sensor are:
Red/white
Blue/White
White/Blue
I dont have a multi-meter to measure voltage right now, so does anyone know how i can run it without having to go into hondalogger to datalog the voltage? This is going on an obd1 h23a motor with hondata 4b. Thanks.