Page 1 of 1
VTC not Engaging
Posted: Thu Jul 09, 2009 8:39 am
by Jordo
When I data log my car for some reason its not switching cam angles at all. Its only staying at 0 degrees.
k20z1
gt35r turbo kit
kpro
any ideas fellas?
When I data log WOT, they are all at 0 degrees.
Posted: Thu Jul 09, 2009 9:40 am
by Spunkster
What is the serial number of the K-Pro board inside the ECU?
Posted: Thu Jul 09, 2009 11:19 am
by Jordo
hardware version 2.16
Serial Number 04997
Posted: Thu Jul 09, 2009 11:40 am
by Spunkster
What vehicle is this in, and what wiring harness was used?
Posted: Thu Jul 09, 2009 12:30 pm
by Jordo
dc2 car, and hybrid racing harness.
Posted: Thu Jul 09, 2009 12:41 pm
by Jordo
When I look at my calbration and my cam angles they range from 0-30 depending on load.
Now when I datalog it only datalogs 0 degrees.
I do have my "vtec oil pressure sensor disabled". im going to try to enable it and see if that allows it to work.
Posted: Thu Jul 09, 2009 1:10 pm
by Spunkster
What engine harness was used?
Posted: Thu Jul 09, 2009 1:38 pm
by Jordo
K20a2 engine harness
Posted: Thu Jul 09, 2009 4:57 pm
by Spunkster
Try your ECU in another known good vehicle such as an 02-05 RSX or Civic SI.