DBW error
Posted: Mon Jul 06, 2009 11:10 am
U0170 is generated by the stock ECU which controls the drive by wire. The OBD II scan tool is connected to the stock ECU and not the K-Pro.
Check the small drive by wire ECU connector is plugged in firmly and to the correct plug.
The Boost-a-Pump testing was done with the pump permanently wired to run 18V. We recommend using the manifold pressure switch.
Check the small drive by wire ECU connector is plugged in firmly and to the correct plug.
The Boost-a-Pump testing was done with the pump permanently wired to run 18V. We recommend using the manifold pressure switch.