Hondata

I am having problems uploading a kal. file to my K-pro. Everytime I try to upload a kal. file it say "upload failed". I can datalog and drive on the ecu fine. I just can't upload a new Kal. file to the ecu. I have used different laptops, updated the usb many times, new usb cord, reinstalled k-managed on my laptop and I also tried the ECU in my 04 rsx and still the same problem. I never had this problem before, untill I needed to get my car tuned recently I ran into this problem.Have anyone had this problem?

INFO:
92 civic, K20a2 swap with R-CREW sub harness, PRC ecu

Hardware: V 1.00
Serial#: 01502
Firmware- V 1.00
Security: Disable
Software: V 1.3.5.4

The first thing to try is to erase the ecu, by going to Online, Tools, Erase ECU. After that completes, turn off the ignition for a minute, then turn the ignition back on and upload a program to the ecu. If that still does not work, ship the ecu to me, as I show that the serial number you have originally came from my shop..

Thanks!

-joe
Locash Racing

locash wrote:The first thing to try is to erase the ecu, by going to Online, Tools, Erase ECU. After that completes, turn off the ignition for a minute, then turn the ignition back on and upload a program to the ecu. If that still does not work, ship the ecu to me, as I show that the serial number you have originally came from my shop..

Thanks!

-joe
Locash Racing

Thanks i will give that a try.

I have the same problem. When i try to upload it say failed. I tried erasing the ecu and that failed.I just tried starting my car after about a 1.5 yrs. of just sitting. I can start the car i just cant upload a cal.
88crx
k20a
hardware 1.0
prc
serial 02036

ver 1.3.5.4

download ver 1.3.7 and still doing the same

jsefx wrote:ver 1.3.5.4

download ver 1.3.7 and still doing the same

i am sending it into get it checked out....