Hondata

Hi,

I have a FN2 civic type R

With the hondata ECU reflash group N I had before the engine light was always off.

I now upload to my OEM ECU the flashpro calibration "reflash group N" and the engine light is on with the error code “P0141 O2 sensor heater circuit malfunctionBank 1 Sensor 2"

I didn’t change nothing in the car.

I have a race header. Is that it? can I run the car?

What is the problem?

Thanks in advance

Nuno

Nuno i have the same problem. After i sold my reflash i instelled stock ECU and O2 sensor is enable. I drive with check system hole month and made about 1000km with any problems. Next week i'm going to install flashpro and disabled this check system light.

thanks marcin,


Hondata, why can't we disable the second 02 sensor with a MAF calibration?

I put a MAP calibration (from the honda SI) and disable the 02 sensor, but I can't do this with the group N calibration.

Why is that?

Did you try in calibration window CLOSED LOOP
ther is ON/OFF primery oxygen sensor enabled and ON/OFF secondary oxygen sensor enabled

there is no closed loop window in a MAF calibration. Only in a MAP calibration.

i think you should install FN2 MAP calibration with racing header...