Hondata

Posted: **Sun Jun 07, 2009 9:55 am**

It seems that all of the standard maps in the kpro have the upper and lower vtec boundaries set at 2200 rpm's.
Should both be set at the same RPM's?

Thanks.

Posted: **Mon Jun 08, 2009 9:33 am**

Which calibration are you referring to?

Different calibrations have different settings. Go to File, New.

Posted: **Mon Jun 08, 2009 3:50 pm**

I used the one for a k20A3 92 octane.
Is this not correct?

Posted: **Mon Jun 08, 2009 4:45 pm**

IF you have a pretty much stock k20a3 then that is the stock setting for VTEC.

Posted: **Mon Jun 08, 2009 4:53 pm**

10-4.
I am pretty stock. I just didnt think that the upper and lower boundaries was supposed to be set that way.

thanks

Posted: **Tue Jun 09, 2009 4:28 am**

Wait, so you have a K20a3 in your mini, not a K20a2?

*OFF TOPIC* Where are you located? That mini looks freakin' awesome!!

Posted: **Tue Jun 09, 2009 3:07 pm**

Yes. K20A3.
Near Houston.

Thanks,

Hondata

Vtec upper/lower boundary K20A3?

Vtec upper/lower boundary K20A3?