Calibration for recently built K20A2?

03DC5R · Post by **03DC5R** » Tue Jun 02, 2009 9:48 am

Hey guys,
I am new to the forum and KPRO, was hoping you could help me out with a new motor i just built for the car.

Type R Pistons(11.5:1)
Type R Cams
RBC
Hondata IMG
Fujita Cold Air
Strup Race Header
GReddy Tic 70mm Exhaust
Stock Injectors(RDX on order)

The motor will be up and running by today or tomarrow, will go through the break in process before i do any WOT, normal drive datalog if needed, but was hoping i could be directed in a good cal to start out with for the motor. Thanks

Drew

cranny · Post by **cranny** » Wed Jun 03, 2009 1:26 pm

its basically an ITR engine , therefore which map do you think would suit it? lol. perhaps the ITR map? haha , im just torturing ya.

03DC5R · Post by **03DC5R** » Thu Jun 04, 2009 4:59 am

Thanks cranny, that's what i assumed, but wanted to be sure. Lol.

cranny · Post by **cranny** » Fri Jun 05, 2009 6:27 pm

haha right on man , good luck buddy.

03DC5R · Post by **03DC5R** » Sun Jun 07, 2009 1:56 pm

Hey Cranny, again thanks for your help. Loaded the K20A cal the other day and car is running great. I was wondering if i could have you take a look at a 20 min log i did the day i drop the cal in. Never did WOT since im still breaking the motor in, but did take it up to about 71% throttle and around 5500rpm. Thanks, let me know.
Drew