Hondata

Hey all,

I recently installed the EP3 engine into my Lotus Elise and seem to have some issues.

I have pushed onto it the k-pro standard map and although it runs fine, when trying to accelerate, it looses power, before a few seconds later pickup again.

I will be booking it in for a proper mapping session, however I would have to drive for 3 hours to get there and my worry is that I would damage the engine.

The set up is:-

Standard engine spec
4-2-1 manifold
No cat
Single narrow band O2 sensor

No knocks. The only errors I get are for the second O2 Sensor and a high voltage one.

I would appreciate a map that would at least get me to the tuners.

Thanks.

I't the O2 sensor error that gives you theese problems.

Engine is running in ERROR mode - a friend of mine had the same issue.

Switch off the ODBII in KManager (that erease the secondary O2 sensor error) and test it.