Page 1 of 1

Wall at 3000rpm

Posted: Wed May 06, 2009 7:51 am
by Mike B
I have:

1) K24a1/K20a2
2) RBC manifold / RDX 410 injectors
3) Brian Crower Stage 2 cams
4) Basic Boltons
5) Hybrid Racing Race harness. - this is the only harness in my race car
In idle. out of gear, I can rev past 3000rpm. My knock count seems to not exist.

Idle AF ratios are 20+.

When I engage the car in gear, I cannot drive past 3000rpm, it sputters, AF ratios are above 20+. The engine was purchased from a local but the tune was sent to me by the tuner. Everything is the same except the injectors which I have changed to 410, from 270. General Fuel trim is 35 and startup fuel trim is 20. Changing either doesnt make a difference.

However, my KPRO manager states that 02 Voltage is 0.00 at ALL times. I have never seen that number move. I imagine that is a bad 02 sensor?

Whats the problem?

EDIT: I am not getting any error codes either.

Posted: Wed May 06, 2009 9:22 am
by Spunkster
You need to take this to a tuner to be properly tuned before you damage the engine.

Posted: Wed May 06, 2009 7:35 pm
by Mike B
I appreciate the advice. I havent driven it for this sole reason. I am replacing the 02 sensor in the mean time because the last thing I want to do is get there, to find out a part is bad. The car needs to be 100% before it gets in the hands of the tuner, T1.

Spunkster, anything else other than the tune? If so, Im replacing it, Im not trying to skimp by.

Posted: Thu May 07, 2009 7:24 am
by Hondata
Follow the posting guidelines. http://www.hondata.com/forum/viewtopic.php?t=3629

I think you have multiple problems.