Hondata

I've read on the S300 section you can toggle between maps by going Parameters > Secondary tables tab

Any suggestions on preforming this with my Kpro/kmanager?

I want to be able to switch between maps on the fly, one for pump gas and one for race fuel

or thinking

a switch between low boost/pump gas and for high boost/race gas

thanks for any ideas on setting this up

There is not room in the ECU for two sets of tables. The hard part would be getting the vehicle to switch fuels on the fly.

If Hi/Low switch activated boost boost control was enabled, and there was also Nitrous switch setup to add or subtract fuel/ignition...

which one would trigger first, if all conditions are made equal?Could I get them to work together thinking about using these this combination to try to achieve what I am doing...

Both at the same time. My point was that changing fuel is not an instant operation, so it would be possible to upload a different calibration.