Page 1 of 1
no air pressure sensor in P28
Posted: Mon Sep 22, 2003 10:05 am
by DevineCRX
I am about to chip a euro p28 (p28-G51) for hondata. When i opened it up, it does not have a air pressure sensor. Will this cause any problems?
Posted: Mon Sep 22, 2003 11:34 am
by DaX
Does it appear to have been removed or that it was never there?
Posted: Mon Sep 22, 2003 11:48 am
by DevineCRX
it was never there
Posted: Mon Sep 22, 2003 11:25 pm
by shinociv
JDM ecu's don't have it either
when you make a chip for your ecu you just need to disable the barometric presure sensor.
If you have ROM editor to program chips it's under the Options tab.
Or tell whoever makes the chip for you to disable it.
even with out it in the ecu and it not disabled the car should run fine
it may give you a error code though.
Posted: Tue Sep 23, 2003 8:06 am
by DevineCRX
thanks..thats exactly what i needed to know...
Posted: Tue Sep 23, 2003 5:03 pm
by Spunkster
You will also need to disable the injector error.
Posted: Tue Sep 23, 2003 5:59 pm
by QUICKSILVER RACING
I was able to tune a p28-G00 succesfully. I used an S200 and P30G stock basemap.
Posted: Sat Jan 17, 2004 5:39 pm
by 5thgencivic
I have a P28-G02 and it doesn't have that sensor either. Do all USDM p28's come with the sensor?
**EDIT** I found out the G in the number means it's not USDM. I wonder what basemap I can use.