Page 1 of 1
datalog stops on dyno pulls
Posted: Fri Apr 03, 2009 9:25 am
by EGHATCH
street tunine at part throttle works with datalog, idle, etc. it never stops
but when i went to dyno earlier, at WOT, datalogging just stopps.
i have to discounnect and reconnect the cable and f10 again...
bkre9ix.
stock ign system
Posted: Fri Apr 03, 2009 11:17 am
by Spunkster
It may have non-OEM plug wires or cap and that may be causing the problem.
Posted: Mon Apr 06, 2009 11:01 am
by crucian
Why do we have to use OEM plug wires and Cap for a product we paid for to tune our cars?
Posted: Mon Apr 06, 2009 11:42 am
by Spunkster
Because they may produce large amounts of interference. This is not something we can control or change on our end. The OEM parts are made to very high spedifications and must meet certain criteria. Aftermarket ignition components do no have to meet these strict criteria and are known to cause problems. We have seen cars make over 900 hp with the stock ignition system.
Re: datalog stops on dyno pulls
Posted: Sat Apr 11, 2009 12:04 pm
by crucian
EGHATCH wrote:street tunine at part throttle works with datalog, idle, etc. it never stops
but when i went to dyno earlier, at WOT, datalogging just stopps.
i have to discounnect and reconnect the cable and f10 again...
bkre9ix.
stock ign system
Also try a different USB port on your laptop if you haven't already done so.