Hondata

in need of a base calibration for a fully built b16 for turbo.

motor is bored/decked/stroked
8.5:1 c/r 84.5mm cp pistons
eagle h-beam rods
b18b1 crank
stock head
rev hard manifold
airesearch stage 3 turbo
synapse wastegate and blow off
3 inch down pipe and 2 1/2 exhaust
750 cc rc injectors
eagle fuel rail
walbro 255 fuel pump w/ synapse fuel reg.

any help is much appreciated.

SIR please trash the WG, they do not work

But the BOV you got a fine unit there

Whats your location and if your close to Cinn Ohio I suggest your call total performance racing or http://www.trpcincy.com and ask ROB to schedule you a 3hr block on the dyno


The best Tuner in the US and even "well PM me for more info" so it's not moderated. S300 right? If so excellent choice