Hesitation/Fuel Cut on light throttle with ITB Setup!?
Posted: Sat Mar 28, 2009 3:07 pm
I have problem on a Lotus Elise with K2x+ITBs. It's a race car. KPro is configured to Alpha-N. Car is tuned so far, no problems (back with 1.3.4 after the terrible buggy 1.3.5.x versions)
The only problem i run into with KPro is, on very light throttle, in gear (car is rolling) it runs into the fuel cut. This happens some times up to 3000rpm!? It's just annoying when rolling on the trailer or through the pitlane :(
TPS is calibrated. IACV is enabled, and connected.
And, and when you add some features, TPS-Tipin would helpful on ITB's and some NA builds, too.
It would be good to have more control over the fuel cut parameters. Like total disable, min TPS, RPM cut/resume ...
Doc
PS: sorry, no calibrations and datalogs, it's a customers car.
The only problem i run into with KPro is, on very light throttle, in gear (car is rolling) it runs into the fuel cut. This happens some times up to 3000rpm!? It's just annoying when rolling on the trailer or through the pitlane :(
TPS is calibrated. IACV is enabled, and connected.
And, and when you add some features, TPS-Tipin would helpful on ITB's and some NA builds, too.
It would be good to have more control over the fuel cut parameters. Like total disable, min TPS, RPM cut/resume ...
Doc
PS: sorry, no calibrations and datalogs, it's a customers car.