Hondata

I have an idea of how to install it!

I have problems with the knocking, I want to install and use the fail-safe function in the ecu

I want to change the timing when you have problems with the Water / methanol system. Here is an idea:

Nitrous/Aux Parameters:



Fuel & Ignition - specifies changes to fuel and ignition when nitrous is activated.

The maximum retard is 40 degrees, and the ignition timing can be retard to a maximum of 10 degrees BTDC.

Diagram Hondata:





5. Fail-safe window output (SW GND)
When flow signal falls inside the fail-safe window,
pin7 will switch to ground immediately. This output
can be used to activate a solenoid valve to increase
boost pressure. This output can also be used to
switch MAP (GND active) on an ECU.

you have any other idea to use the fail-safe for Aquamist?

i always joke about how my integra sounds like a p52 mustang... i really would feel like an old fighter plane with some methanol rofl.