Hondata

Posted: **Thu Feb 05, 2009 3:19 am**

I use hondata ecus with OBD2a and OBD2b built in connectors.

I wish to use the OBD1 pin references D12 & B6 on these ECUs, but I need to know which pins to feed them into?

thanks

Posted: **Thu Feb 05, 2009 9:13 am**

I do not believe that these OBDI pins are connected to the OBDII connector.

Posted: **Thu Feb 05, 2009 10:42 am**

http://www.hondata.com/techadapters.html

Posted: **Thu Feb 05, 2009 12:28 pm**

spunkster, thanks for the link, it would appear that b6 was not listed at the time.

:?

Hondata the how can i check for certain?

these two inputs are critical for me, I AlWAYS use them for various customers with OBD1 / adaptor harness.

Posted: **Thu Feb 05, 2009 12:53 pm**

B6 is not built in. You will have to run a wire to that location...this may involve soldering dierectly to the board if you have a build in adapter harness.

Posted: **Thu Feb 05, 2009 3:42 pm**

D12 definitely built in?

:(

Posted: **Thu Feb 05, 2009 3:52 pm**

Please look at the link I posted above

Posted: **Thu Feb 05, 2009 3:56 pm**

I did look at the link posted above but since ou were telling me one ma not be connected on the ecus with built-in adaptor, I wanted to know from the source if the other was.

I will get one from stock and check it over.

Hondata

analog inputs with OBD2a/2b Hondata ecus...WHICH PINS?

analog inputs with OBD2a/2b Hondata ecus...WHICH PINS?