Hondata

Hi, could help me with a map?

b16a2 with internals
8.6 : 1
AR .50 / .63
ported and polished
stock camshafts & springs
regulable pulleys
light weigth pulles
flywheel
clutch stage 4
780cc injectors
S300
fuel pressure regulator
msd 6AL

Thanks!!!

what PSI do you plan on running?

cranny wrote:what PSI do you plan on running?

I hope to get 20 psi using 106 octane gas and also with 91 octane a little bit psi I think

In my country (Ecuador) having a racing car is really difficult because there's nobody with enought knowledge to program hondata, fuel sucks and also doesn't even exist a dyno!! So that's why I'm asking for your help please!!

how do you control your boost?

cranny wrote:how do you control your boost?

External waste gate
Manual boost controller

I also forget to mention I have a 255 lph walbro fuel pump

what map sensor you running?

motorola 2.5 bar MAP

thanks

this is the b16 greddy turbo basemap , i adjusted it for your injectors and map sensor. turn your boost down as low as it goes , start there. i enabled lean protection as well. see if the car runs normally , ALWAYS keep an eye out what your air fuel ratio is reading.

i assume you have a wideband wired up and ready to go?

not yet, I have an auto meter air/fuel meter

you need a wideband , dont drive the car till you get one , youl blow it up.

thanks... the next week I'll install the wideband...

Could use only the 5 wires sensor or I'll need the wideband gauge?
Thanks...

you need the gauge too as it controls the sensor. hondata recomends the PLX.

Thanks again Cranny... could you send me your email?