Page 1 of 1
HELP PLX INSTALLATION S300
Posted: Mon Jan 19, 2009 11:40 am
by celicagt4
THERE IS ANY WAY TO CALIBRATE THE M300 PLX WIDEBAND OR IS JUST INSTALL THE WIDEBAND AND I DON'T HAVE TO DO ANITHING IS GOING TO BE COMPLETED AFTER INSTALLATION? PLEASE ANY ADVISE :(
Posted: Thu Jan 22, 2009 2:29 am
by hiperformance
I would search the help files or this forum for more in depth information. but....
Go to: parameters, Closed Loop. the wideband lambda table is at the bottom of that page. I believe the voltage/ conversion table is already preset for the PLX. 0v=10 and 5v=20. from there you choose which input source you are using and change the offset voltage +/- (start small) like 0.1 or -0.1 until the display on your laptop matches the display on the PLX. at least thats how i did it. if thats not right, someone else can chime in.
Posted: Thu Jan 22, 2009 10:44 am
by Spunkster