Page 1 of 1
S300 Help
Posted: Fri Jan 09, 2009 8:50 pm
by inte
I keep getting a red blinking light on the usb attachment of the hondata. I know it is supposed to be green. When I am connected it won't let me do anything and it tries to update the firmware data. Has anyone seen this...
Posted: Mon Jan 12, 2009 10:25 am
by Spunkster
From Help, About, what version of software are you using?
Posted: Mon Jan 12, 2009 3:06 pm
by inte
1.4.0.0
Posted: Mon Jan 12, 2009 5:23 pm
by Spunkster
What happens when it tries to update the firmware?
Posted: Mon Jan 12, 2009 7:20 pm
by inte
Nothing, if I try datalogin or try to update to the ECU it tries to update the firmware data. It keeps going and going. It doesn't seem to work. It won't let me do anything.
Posted: Tue Jan 13, 2009 10:22 am
by Spunkster
It will not update firmware while datalogging. Close Smanager, reopen it, load a base calibration from File, New, and then upload the calibration. If it tries to update the firmware, let it and do not cancel or interrupt power.
Posted: Tue Jan 13, 2009 10:46 am
by inte
I will try that. But I know that if I try to load anything to the ECu it will try to update the firmware. After is done updating, if I try to load to the ECU it will try to update again. Any idea why I have a red blinking light on the USB port. I know that when I turn the ignition it is suppossed to be green.
Posted: Tue Jan 13, 2009 7:26 pm
by inte
ok, opened new calibration, but the same problem keeps happening. it is trying to update the s300 firmware. After it updates it continues to do it over and over it doesn't stop. I keep having a red blinking light on the USB.
Posted: Wed Jan 14, 2009 11:06 am
by inte
This s300 is bad, how can I get it repaired.
Posted: Wed Jan 14, 2009 11:53 am
by Spunkster
Please call us to obtain an RMA number and get instructions and details.
310-782-8278