Hondata

Posted: **Sun Nov 16, 2008 4:49 pm**

I have a UK engine / harness and a PRC Jap K-Pro ECU, the harness is modified for the Wideband sensor as shown on this site.

The problem I have is with a UK ECU the car starts and runs perfectly but with the Jap ECU the fuel pump does not spin and hence wont start.

It seems that a jumper is missing in the Jap ECU (J160) which connects pins E1 and E10. It seems that if I connect to the fuel pump wire to E10 instead of E1 everything will be happy.

Has anyone come across this before?

Thanks

Phil

Posted: **Mon Nov 17, 2008 10:57 am**

Who installed the K-Pro for you? What is the K-Pro serial number?

Posted: **Mon Nov 17, 2008 2:37 pm**

ecu serial number is 2070-102498 0H09
37820-PRC-013

I bought the ECU already done so I have no idea who did it, although I could find out if I contacted the seller.

Posted: **Mon Nov 17, 2008 4:27 pm**

I need the serial number form the K-Pro board inside the ECU.

Posted: **Tue Nov 18, 2008 12:47 pm**

oops sorry

05000517

Phil

Posted: **Tue Nov 18, 2008 1:41 pm**

Contact CPL Racing and they should be able to assist you with getting this working for you.

Posted: **Wed Nov 19, 2008 2:28 pm**

I took a gamble added the jumper and now the ecu works with the wiring as described on this site. It might be worth a mention on the wiring instruction page that this could be a problem as I found nothing about it anywhere.

Thank you.

Phil

Hondata

Fuel pump relay wiring

Fuel pump relay wiring