Hondata

Hi all,
I am new to hondata and learning about it everyday.

I am looking a similar calibration of my setup before going on dyno

my setup is:
k20a2
3" intake
R-crew header
no cat
2.5" exhaust
tsx exhaust cam
stock PRB IM
fuel pressure at 50 psi

i tried most of the map from my kpro, even with some others map, no clue why the car run strange at vtec point and so rich at high rpm

if anyone hv a similar setup (tsx cam) please share and welcome to discuss, I am using the ITR kal now with + fuel at lower rpm, seems to be the best now...

you sure the timing is all good? not sure how these engine react to cam timing being of a tooth but. you want help , post up your calibration and a datalog. ill help you.