Hondata

I am trying to datalog a pressure sensor in B6. As hondata instructions, I cut R2 and R3, but after that, the car did not start. I soldered them back in and the car started working again.

So I looked at the help file more. In the pic, The pointer does not point to R2 and R3, it points to D1 and R6. I thought it was just off, but I looked at C42 and it was pointing to the correct spot. Maybe there is a typo somewhere?

R2 and R3 are slightly to the right of D1 and R6 - we'll update the picture.

We'll test this but cutting R2 and R3 should be ok.