Page 1 of 1
How do i revert a hondata ECU to run as stock?
Posted: Sun Aug 17, 2003 2:01 pm
by sung
I purchased a ECU that was already chipped/socketed for hondata but i need to use it without the hondata settings for a little while... what do i have to do to make it run like a stock ECU?
Posted: Mon Aug 18, 2003 10:48 am
by Spunkster
cut jumper J1
Toggle switch?
Posted: Sat Mar 05, 2005 1:18 am
by Phat4Door
So if I send my GSR ecu off to hondata and get it chipped and then get it back and put a toggle switch on j1 I can put it in my car and run it until I can get a base tune and then flip the switch back and forth between stock and the hondata? Is this correct, because if so I will send my ecu off monday.....
Posted: Mon Mar 07, 2005 8:59 am
by Phat4Door
Anyone? I can't find an answer to this one anywhere hoping someone on here can help me....
Posted: Mon Mar 07, 2005 9:11 am
by Hondata
Yes you can, but why?
Posted: Mon Mar 07, 2005 8:42 pm
by Phat4Door
Basically so when I get my ECU back from being chipped I can still run the GSR program until I have the time and money....mostly the money to pay to get it on the dyno that is 1 and a half hours away to get the base tune, once I get the base tune I don't need the switch, but basically I was wondering that so I didn't have to go out and get another GSR ecu to run my car until I got the base tune....Thanks