Page 1 of 1
I downloaded update for kpro and now my car wont start HELP?
Posted: Wed Sep 17, 2008 5:09 pm
by EK_K20R
So I just downloaded the newest version after my 2.16 and now that I updated my software to 2.18 my car wont start.
I downloaded from my ECU first then I uploaded it back into the ECU and this is the outcome...
Any HELP???
Or tips on what I should do.....?
Juni
Posted: Thu Sep 18, 2008 2:59 am
by fonz600
Downloading the map from your ECU should be done with caution as problems can arise.
Try clearing your security, switch off ignition, clost down kmanager then restart it again and switch on ignition and uploading it again.
If not working try and upload a map from the calibrations folder similar to your mods and see if it'll start.
If still got probs uninstall kmanager and do a fresh install.
Posted: Thu Sep 18, 2008 4:08 am
by EK_K20R
fonz600 wrote:Downloading the map from your ECU should be done with caution as problems can arise.
Try clearing your security, switch off ignition, clost down kmanager then restart it again and switch on ignition and uploading it again.
If not working try and upload a map from the calibrations folder similar to your mods and see if it'll start.
If still got probs uninstall kmanager and do a fresh install.
ok I will try that this evening...
Thank you!
Posted: Fri Sep 19, 2008 3:57 pm
by EK_K20R
it worked.......thanks!
Posted: Sat Sep 20, 2008 3:25 am
by fonz600
No probs mate. Glad I could help.