P72/S300 Installation

EKJOE · Post by **EKJOE** » Tue Sep 16, 2008 10:21 am

Hey Everybody,
So I just bought my S300 a few days back and went ahead and installed it...Everything was pretty straight forward and simple, I just have a few questions.

Is there an R54 on the P72? (Resistor)

Is there a J12 on the P72? (Saw J11 but no J12)

I have scoured my ECU looking for these two, But have not found them.

Any help is greatly appreciated.

Post by **Spunkster** » Tue Sep 16, 2008 12:56 pm

J12 is in the same place on all OBD1 ecus

R54 is not present on a P72 or P75....just ignore it.

EKJOE · Post by **EKJOE** » Tue Sep 16, 2008 3:05 pm

Thanks for the info, I'll check that area of my ECU again for J12 when I get home.

So whats the deal with the 220uF 50v cap that came with my s300? The installation instructions never mention anything about that.

I only see one cap on the board that it could replace.

Post by **Spunkster** » Tue Sep 16, 2008 3:34 pm

http://www.hondata.com/tech_capacitor_obd1.html

EKJOE · Post by **EKJOE** » Tue Sep 16, 2008 5:51 pm

Thank you VERY much!