Page 1 of 1
CAM Command always at 0
Posted: Wed Aug 13, 2008 7:28 am
by magnEsium
A friend just bought K-Pro, I gave him a kal for his vehicle and his cam command is always at 0, it does not change ever even though the tables say otherwise
No CEL's thrown, VTC is enabled, just simple bolt ons, 2005 rsx-s
Car is warmed up, all engine sensors were checked and rechecked
Any ideas?
Posted: Wed Aug 13, 2008 8:00 am
by Hondata
Posted: Wed Aug 13, 2008 8:26 am
by rdiablos330
how do i find the serial number? i cant find the paper..
06 rsx type s
kpro
injen cai, rbc manifold, sturp rh, tanabe catback
the problem i have is what magnesium said
Posted: Wed Aug 13, 2008 10:37 am
by Spunkster
open the lid and look at the K-Pro board.
Posted: Wed Aug 13, 2008 2:46 pm
by rdiablos330
4087 is my serial number
Posted: Thu Aug 14, 2008 7:17 am
by rdiablos330
so any comments on what could be wrong with the car??
Posted: Thu Aug 14, 2008 7:51 am
by Hondata
You have an error code - P0112 "IAT Sensor Low Voltage"
Posted: Thu Aug 14, 2008 10:02 am
by magnEsium
Hondata wrote:You have an error code - P0112 "IAT Sensor Low Voltage"
That wouldn't cause the angles to lock at 0, would it?
Posted: Thu Aug 14, 2008 11:32 am
by Spunkster
Yes it will.
Posted: Thu Aug 14, 2008 12:18 pm
by rdiablos330
ya thats the code.. so just get a new iat and im good?
Posted: Fri Aug 15, 2008 9:11 am
by Hondata
If there are an error codes always track down and fix them before doing anything else.
Follow the Helms manual troubleshooting for the IAT error code.
Posted: Fri Aug 15, 2008 11:26 am
by rdiablos330
i put in the new sensor and the code is still there. once i clear it it comes back on. when i clear it n dont let it idle on its own, by revving the car it stays off. but it works the whole time as long as i keep the rev high.. once i let it idle alone the engine light comes right back on and the kpro craps out.. what should i do? and i dont have the helms manual where can i get one?