Hondata

hi there

i have a hondata s200 unit connected to a chipped p28 ecu

my question is can i unplug the s200 unit from the ecu and then use the ecu as normal with a new chip installed?

You may hav eto replace J12 and it all depends on the chip you use.

well the reason i asked is because every chip i use (i have like 4 or 5 now) i get this problem

http://hondata.net/forum/viewtopic.php?t=7998

so i was thinking id try it with the s200 unit disconnected and see what happens

do i have to use a chip that has been tuned with hondata for the above not to happen? or can i use a base map with no problems? if that makes sense??

The interface box will only work with a Hondata ROM.