Page 1 of 1
K20A Calibration request asap
Posted: Mon Jul 21, 2008 8:50 pm
by Pro_14481
Need a calibration for an eg K20a with custom intake, exhaust and R-crew header...PRC. Running about an 11:1 A/F at WOT atm lol.. Also throwing a P166 Primary 02 sensor code. Thought that was the problem for running rich but the fuel maps are significantly higher than they should be.. have no clue why since the car was dynoed about 4 months ago at 12.9 A/F, but purchased the car about a month ago..Anyway, going to the strip this weekend and need a better calibration then what i have if possible...thnx
Posted: Wed Jul 23, 2008 2:19 pm
by fonz600
Kmanager has a itr map which is K20A in the calibrations folder. Toda mani etc as well.
Posted: Wed Jul 23, 2008 2:47 pm
by Pro_14481
yeah i tried that cal. but it runs pretty lean, especially under partial throttle. idk i guess ill try the k20a2 with itr cams 310cc and bolt ons calibration, i just want the car running at its near best, and there is no dyno remotely close to where im at..
Posted: Thu Jul 24, 2008 2:39 am
by fonz600
Just add fuel where it is running lean then mate.
If your not sure just upload your map and datalog.