Page 1 of 1
PND-A08 ECU insetad of PRA [European EP3]
Posted: Sat Jul 05, 2008 5:51 am
by eTiLiKo
On a European EP3,that mount from the factory a PRA ECU,can be mounted a PND-A08 ECU with a Kpro on it?I mean without harness mods.
Is it a free-issues operation?
Thanks
Posted: Mon Jul 07, 2008 8:32 am
by eTiLiKo
It is sufficent to have the pinout of hte PND-A08,but i havent't it.
Posted: Mon Jul 07, 2008 10:10 am
by Spunkster
This will not work properly without making wiring changes and installing a wideband o2 sensor.
Posted: Tue Jul 08, 2008 2:25 am
by eTiLiKo
Ah,ok!
Can you help me with the wiring changes?I already have this ECU with the Kpro on it,so I have to mount it. :roll:
Thanks a lot
Posted: Tue Jul 08, 2008 9:57 am
by Spunkster
Posted: Tue Jul 08, 2008 3:34 pm
by eTiLiKo
Thanks a lot,I know this page.
I had miseunderstood : I believed that I had to make further changes than those for the o2. :oops:
So,when I make the o2 wiring modify all works fine?
Posted: Wed Jul 09, 2008 2:37 am
by eTiLiKo
And another question : the new O2 sensor [36531-PRB-A01] have trhe same connector of the "old" primary narrow?
Posted: Wed Jul 09, 2008 9:20 am
by Spunkster
I believe the connector is the same, but since we do not have these cars in the US I do not know for sure.
Posted: Sun Jul 13, 2008 9:46 am
by eTiLiKo
Can be another solution to unsolder Kpro from PND and mount on the PRA?
Posted: Sun Jul 13, 2008 4:27 pm
by Garrett_si
the k-pro is not soldered
but it couldn't be put into another ecu since the board need modifications
Posted: Mon Jul 14, 2008 5:13 am
by eTiLiKo
Yes,i want to say replicating all the necessary mods to the PRA board.
Posted: Mon Jul 21, 2008 3:06 pm
by eTiLiKo
Spunkster wrote:I believe the connector is the same, but since we do not have these cars in the US I do not know for sure.
Yes,the connector of the wideband is the same of the narrowband.
I have mounted it and made the mods,the car start with no problem 8)
