Hondata

I have a civic EK with a swap K24/K20 with ITB, skunk2 cams stage 2, CP high compresion pistons and R/C 550CC inyectors

After I load the base calibration and start the engine the red light on the ECU still on, didn?t datalog and 2 cylinders where not working on idle.

then I used a friend?s Hondata ECU same as mine, load the base calibration and everything work perfect and the light on the ECU stay green

I call the person that sold me the ECU and the just told me the problem is on the calibration or a protection activated.

anybody have any clue? :roll: thank you very much

no help?

another thing my friend ECU have and older firmware than mine

If you go to online, tools and clear security, close the program, reopen it and go to file, new and laod a new calibration into the ecu and the problem persists, I would recommend getting your money back from the person that sold you the ecu.