Hondata

Does anyone know if the A/F gauge problem has been fixed yet in the latest version of Smanager?

There are no known issues with the A/F guague display.

Spunkster wrote:There are no known issues with the A/F guague display.

I get the message "Floating point division by zero" everytime i try to open a A/F ratio gauge in the Display part of Smanager. It keeps popping up non-stop to a point where i have to close it or else it'll freeze my laptop. i have the latest version of Smanager. I'm running Vista. I try to delete the current display files but that doesnt do anything. I even try to get some of the demos that i downloaded here with the A/F gauge and those files open but wont work. is this just a windows vista thing?

In Smanager under Settings try both lambda unit options (air/fuel and lambda).
If you have a calibration loaded then under Closed Loop check the voltage/lambda conversion - none of the air/fuel or lambda numbers on the bottom line should be zero.

Hondata wrote:In Smanager under Settings try both lambda unit options (air/fuel and lambda).
If you have a calibration loaded then under Closed Loop check the voltage/lambda conversion - none of the air/fuel or lambda numbers on the bottom line should be zero.

alrite. got it to work. another hooray for hondata! works awesome.

Im having the same problem. I have tried both A/F and Lambda in Settings, and under closed loop, neither the lambda or A/F is 0. Any solutions??

I too have the same problem.
I have done as instructed above with no difference.
I've had to re-install SManager twice now. This is the third time it has happened in the matter of hours.

This time it has deleted all my display files too. When I click on "display" I get the error as mentioned above, I click "OK"...I then click on "display" once again to get an error of "can not open file...default.display".

Download one of the displays from the forum that I have posted and then go to Display at the top and load the display you have downloaded.

The problem must be with how you are setting up the displays.

This was with me using a Hondata supplied display. Today I started creating a new display of my own...so far so good.

I don't understand why this problem comes and goes.

i also have this problem but am now going to just download a display, but it happened as soon as i put the AF guage in?