Page 1 of 1
loud beeping noise when starting datalog
Posted: Sun Jun 08, 2008 10:31 pm
by V-Spec race development
Has anyone have this problem? I never heard this beeping noise before til now. Every time i start to datalog, the beeping start and it get annoying. Please let me know how I can turn that off besides turning the volume down or muting it. Thanks in advance.
Posted: Mon Jun 09, 2008 10:50 am
by Spunkster
Change the setting of your display. You have set a warning for something.
Posted: Mon Jun 09, 2008 11:58 pm
by V-Spec race development
spunkster, how can I change my setting on the display? Sorry for asking. I downloaded this display from one of the member from display template forum. thank you sir.
Posted: Tue Jun 10, 2008 9:36 am
by Spunkster
Are you sure you have not downloaded a Kmanager display?
Posted: Tue Jun 10, 2008 9:43 am
by V-Spec race development
I'm sure I downloaded the Smanager template. If you look at the top left corner of the display screen it says "Hondata Smanager 1.3.6.0- display" Thank you for looking this up for me Spunkster.
Posted: Tue Jun 10, 2008 11:24 am
by Spunkster
SManager will always say SManater at the top. IT is possible that you downloaded a display that was created for KManager though and have loaded that into SManager by mistake. Try downloading a different display and see if it works better for you.
Posted: Wed Jun 11, 2008 12:21 am
by V-Spec race development
ok i will do that. I"m going to load the one you loaded title " amber full cluster display" and see if that works. I'll let you know. thanks again.
Posted: Thu Jun 12, 2008 7:13 pm
by V-Spec race development
I uploaded the display above and it works. No more beeping while datalogging. Thank you Spunkster.