AFR readings stopped working as off version 1.2.3.3
Posted: Thu May 29, 2008 8:21 am
JDM Honda Integra Type R 2003
PRC ECU.
With version 1.2.2.8 I have a reading from the wideband and am able to datalog.
I then upgraded to 1.2.3.3 and now I getting a reading of 00.0:1 I swapped out the wideband with a known good one and was still getting a reading of 0 I then upgraded to 1.2.3.5 and the same thing happened. I then put version 1.2.2.8 back on and all of a sudden I started getting AFR readings again.
With these newer versions the wideband is still functioning as I am getting S.Trim fluctuation of -1% -2%, it just doesn't display it in the sensors log/graph.
I will attach a datalog later.
PRC ECU.
With version 1.2.2.8 I have a reading from the wideband and am able to datalog.
I then upgraded to 1.2.3.3 and now I getting a reading of 00.0:1 I swapped out the wideband with a known good one and was still getting a reading of 0 I then upgraded to 1.2.3.5 and the same thing happened. I then put version 1.2.2.8 back on and all of a sudden I started getting AFR readings again.
With these newer versions the wideband is still functioning as I am getting S.Trim fluctuation of -1% -2%, it just doesn't display it in the sensors log/graph.
I will attach a datalog later.