Page 1 of 1
Quick Question
Posted: Wed May 07, 2008 7:55 pm
by jatt
can some one help me out.. i just got hondata s300 if i want to load a stock map on it do i just load it from the Calibrations folder then i press Ctrl+u will it over write the old map it had on it?
Posted: Wed May 07, 2008 9:28 pm
by element
dont have to delete the old one just open the map you want and press ctrl-U
its gonna upload your map on the ecu. than your good to go
Posted: Thu May 08, 2008 1:19 am
by jatt
Can some one Answer my question thx..
Posted: Thu May 08, 2008 9:34 pm
by jatt
Can Some one Answer my Question on post 1 Thhx
Posted: Fri May 09, 2008 9:32 am
by Spunkster
Go to File, New and select your calibratio you wish to use, then upload it, this over writes anything on the ecu.