Hondata

i cant seem to get datalog to work on the new software.. even the tuner was puzzled.. on his laptop wit v1.3.3 it works fine.. but on my laptop wit the newer version i cant log nothing.. y is that? thanks

still the same!!! wut is the problem??? i cant seem to datalog

damn no one on here can help out about this dataloggin problem?? doesnt that just kills the whole purpose of paying for the s300 unit?? comeon guys help me out here its getting on my nerves not being able to datalog

Have you uploaded the calibration using the 1.3.5.0 version of the software? WHo socketed the ECU? Has J12 been cut on the ECU?

yes i loaded the calibration with the new software.. hondata socketed the ecu.. its funny cuz it was dataloggin wit smanager v 1.3.3 when i was at the tuner.. got home loaded the map off my laptop using v1.3.5 and it'll datalog for like 30 secs and freeze up

If you go to ECU information (blue "i" button) what does it say for the firmware version?

1.04

What happens if you go to File, New and create a new base calibration and upload that with the key in just the on position but the motor not running and you try to datalog?

it'll show the sensor voltage n all it'll work like that but once u start the car it starts trippin out

allmotorh22a wrote:it'll show the sensor voltage n all it'll work like that but once u start the car it starts trippin out

Did you make sure that onboard datalogging is disabled while datalogging from the computer?

If not, that will **** it up like you are stating.

yes onboard dataloggin is disable.. thanks for the input tho

If it datalogs fine with the car not running then you have an interference issue with the ignition. What spark plugs do you have? What ignition system are you using? What plug wires are you using?

stock ignition system ngk spark plugs, ngk plug wires

Are the plugs non-resistor or resistor type? What part number?

ngk:

stock no. 5030 BCP7ES