Page 1 of 1
k20a2 turbo cal needed
Posted: Tue Apr 15, 2008 10:59 am
by }{bLaZe}{
i got an 02 type s with a custom turbo kit running around 10psi does anyone have a good cal i could use ? i got a catback exh so..
Posted: Sat Apr 19, 2008 8:41 pm
by dustyboner
you might be able to use this .kal. if your at a low altitude, you may need to increase the overall fuel trim a little.
k20a2 9.0:1 compression
1mm oversized valves
t3/t4 60trim
750cc injectors @ 43psi
3" exhaust, no cat
elevation 5200ft
Posted: Tue Aug 26, 2008 12:09 pm
by johnpest2
What changes for K24 with 750 cc Wiseco pistons
rods
10.4:1
GT K 61 trim T4
K20A head
Avgas
5300 ft
Re: k20a2 turbo cal needed
Posted: Tue Sep 09, 2008 8:19 pm
by cranny
}{bLaZe}{ wrote:i got an 02 type s with a custom turbo kit running around 10psi does anyone have a good cal i could use ? i got a catback exh so..
im sure you could load the 10 psi cybernation map and tune from there. just make sure you change the fuel trim injector size for yours.
Posted: Mon Sep 29, 2008 9:45 pm
by }{bLaZe}{
ok so now i got my car back i got 440cc injectors off club rsx i have eagle rods and mahle low compression pistion i think there 8.6-1 not sure but when i start the car it doesnt wanna idle any ideas and its running rich and when ever i clear security on the ecu it runs but the sensors dont work i guess cuz it runs rich but it idles so i have no idea im still new to this the car has been down for 3 months and im looking for some helpfull advice to getting it back on the road...thanks in advance
Posted: Mon Sep 29, 2008 10:08 pm
by cranny
post a datalog of the car starting an running and your calibration.
Posted: Fri Oct 03, 2008 12:41 pm
by }{bLaZe}{
id post one right now but the car wont start we found out the map sensor is bad so the new one should be in today after we put that in well see if it starts and ill post a datalog of the car