Hondata

so i've been trying to get my mac to work with the s300. I've installed the parallels program, along with windows xp and the smanager. but everytime I try to upload a map, the little progress upload bar goes about 2/3 of the way across, stops, then tries again, for a few times, until it just says upload failed. at first i thought the socketing was bad, but with a regular windows laptop i can upload maps fine. I've installed all the drivers and whatnot needed through smanager on the mac and it still won't work. Has anyone does this before or have some good advice?

i actually work for applecare so yea i have a few suggestions, first ditch paraelles for now and try the bootcamp if ur running 10.5 ofcrouse

if that doesn't work then i am not too sure b/c when loaded into bootcamp its like running natively in XP so let me know

ditch parallels garbage and get VM Ware Fusion.

It will probably work and it can launch a boot camp partition just like the others but shit actually works.

It's always worked fine for me.

Try restarting the virtual machine after plugging in the s300.