Hondata

I have the GM boost solenoid 1 wire connected to the battery for the power and the other wire connected to A11 i think.


I have the Boost control enabled and normally open clicked and fixed duty cycle set to 0%. Its not hitting 7 pounds like in the wastegate spring. Its keeps on hitting boost cut set to 10. I am trying to get it to what the spring is set for. What am i doing wrong?

What happens when you just disable boost control?

it goes past and spring pound and hits the boost cut set to 10. iv pulled the vac line off also and it went to 7 which is the spring

A normally open solenoid cannot be disabled or set too low. Since it is normally open, activating the solenoid is actually closing the flow of air off..try setting it to 15% and then 25% and see what it does.

i have the same exact problem. boost cut set at 10, boost set for 7, spring is 7psi. but it always goes to boost cut. got any other ideas? i tried normally open at 25% 15% and 5%