Hondata

So I am taking the RSX out to the track next friday, I already know I am going to get in about 3 runs if that, so I will not be messing with fuel/ignition for different cam angle tables.
I want to leave the cam angle map alone as it is in the basemap and just dial in the fuel as best as I can during the limited amount of runs and play a bit with spark advance. Will I be able to get the fuel mixture if I were to use the Edit all the tables option for low and high cam, instead of dialing in each individual cam angle. Is it possible?

TLtypes wrote:So I am taking the RSX out to the track next friday, I already know I am going to get in about 3 runs if that, so I will not be messing with fuel/ignition for different cam angle tables.
I want to leave the cam angle map alone as it is in the basemap and just dial in the fuel as best as I can during the limited amount of runs and play a bit with spark advance. Will I be able to get the fuel mixture if I were to use the Edit all the tables option for low and high cam, instead of dialing in each individual cam angle. Is it possible?

Sure can, just use the Lambda Overlay for fuel. I suggest you find some nice long, deserted roads before you go to the track and do some 3rd gear pulls whilst tuning A/F via Lambda Overlay, should be no longer than 4 or 5 datalog sessions, then if you feel comfortable advancing knock without a dyno, now would be the time to do it, of course if you get knock, then you'd be removing ignition.