Hondata

Anyone runnning the above and can give me a map?

Im currently running one that the previous k pro owner had for a toda manifold, toda catback and aem cai. I dont think this will be a million miles away from what I need for the above but I thought I would ask anyway

cheers

I have Spoon 4-2-1 + B-pipe + Fujita CAI - I'm going to hook up the Innovate LC-1 lambda and do some tuning.

Will let you know when it is done, but it will be ready not sooner than end of next week.

So far I have found that the spoon is quite strange piece of header ... it doesn't like VTEC to be much lower than the standard (5200RPM).

I'd say it's pretty *$&()&(%&^ .... will se after some time spend on it.

Dan

TerryCTR wrote:Anyone runnning the above and can give me a map?

Im currently running one that the previous k pro owner had for a toda manifold, toda catback and aem cai. I dont think this will be a million miles away from what I need for the above but I thought I would ask anyway

cheers

Are you using a PRB K-Pro or a PRA. Its just the map you have got already is something what i am needing.

If so could i try yours. I have a few maps but nothing with the spoon header as i run toda and also maxim works headers both of which are PRB Maps but i do have one PRA Map but again its a toda header. Could work thou

Let us know pal.

Chris

Hi,

here is map that I'm running atm. IGN is untouched and N98+ is recommended. The car is running real strong from 5500rpm up to 8600.

cheers

Dan