Hondata

hi - sorry if this is a dumb question. i just installed a gm 3 bar instead of my stock map. i went under the option to change the type of map sensor. i chose custom a scrolled through and did not see the gm 3 bar as an option. am i missing something. is it listed as some other type of map? i would appreciate the help. thanks!

IT may be similar to the Motec, but then again it may not be. THere are several different GM sensors so we do not recommend their use.

what part# is your GM map?

I got the same prob

Here's the map

UP ?

Please ?

You have to go unde the custom and figure out the Scalar and offset yourself..... so.... check this out i think this what you might be looking for http://hondata.net/forum/viewtopic.php? ... ght=#23621

let me know if this helps GL

I've noticed a lot of people that are using the GM/MSD 3 bar map have the Motec 3 bar selected. There is an option in the newest release though that does have the GM 3 bar as a selection.

I personally am using the Motec 3 bar setting and it appears to work just fine...

Same thing !

I run the Motec 3 bar right now and it works fine