Hondata

Ok so i got my charger mounted up and did a few pulls. I had noticed that i keep fouling my plugs and it's now a problem so, after looking at the a/f it seems to be too rich. When in boost it was running 11.3 - 11.5, I think it should be 11.8 - 12.3 (correct me if i'm wrong.) This is my most recent pull and i'm still getting way too many knocks so please tell me what you think. I pulled some more fuel out from 65-7500rpms to bring it up a bit and i will post that log later in the day. Thanks for the help. Oh yea, it's an 03 ep3 k20a3, 2.5 mid pipe and comptech ice box.

did you ever get this fixed??? I have the same problem

If you have a Jackson charger this could be that the shaft within the charger is on its way out ( production fault ) and this sets the knock sensor off as the frequency is about the 10khz mark .
check the end seal on the charger ( behind the pulley ) if it is leaking oil get it checked .

other than that what size pulley are you running ?

just seen you are running 4'' pulley