Hondata

well i had a daughter board error so i pulled over so that i could clear ecu cause the dtc reset didnt work...

while i was clearing the ecu the negative terminal on the battery came off and it still said it finished but now it wont start.....and it seems it was shorted or something....

now when i upload the kal and it will NOT reset the fuel pump or click when uploaded just finishes no sound nothing....

car wont start it just boggs......... and stalls

so i tried resetting batter and re-uploading kal.......nothing

i tried downloading and says access violation, kmanager...

i have an rsx with type S prb ecu

http://www.hondata.net/forum/viewtopic.php?t=3629

Fix the battery terminal and check the master wiring harness ground (normally on the intake manifold) is good.

Download and install the latest version of KManager.

Clear security, leave the ECU five minutes with the ignition off, clear security again, wait 5 minutes with the ignition off and then upload a calibration.