Hondata

hello

on Kmanager.ini file, I put dataloggingout=1 for AIM MXL

it seems like only PRB ecu has datalogging feature

I was wondering if there is any way i can use dataloggingoutput function on PNF ECU

if not, is there any other way PNF ECU can send datas to AIM MXL cluster?

the wiring is either connect hondata board from AIM to E24 pin, or use RS232TX and RX wire to somewhere else

please help me with this

if you can release new kmanager with PNF datalogging function, that would be great!

Yes, you are correct in that the PRB is the only ECU which supports the datalogging output. The PNF does not have enough room to add this feature. Your best approach would be to use PRB calibrations (which will work in the PNF ECU).

Hondata wrote:Yes, you are correct in that the PRB is the only ECU which supports the datalogging output. The PNF does not have enough room to add this feature. Your best approach would be to use PRB calibrations (which will work in the PNF ECU).

Thank you for reply!

I was worried that it won`t ever work

The other question is, is it possible to get CIVIC SI JRSC 440in 4.0pulley PNF calibration copied as PRB calibration file? (If you guys have one and I can download from somewhere, that would be great!)

or do i have to make whole new calibration?

also, there is two option for datalogger output which is 9,600 bps and 115,200 bps. which one should I use?

You would have to make a new calibration if you use a PRB calibration.

Check with AIM to see what baud rate they use - I think it is 9600 bps.