Hondata

Posted: **Sun Nov 18, 2007 7:59 am**

Hello Peeps,

having a small problem. i have a EK9 fitted with the s200 the cel light is on all the time, i have replaced the ecu with a p28 , i have changed out the s200 with my own dealer one i have changed the roms etc nothing seems to cure the cel. in hondalogger no error codes are coming up any ideas , has anyone had this happen to them before.

regards

Posted: **Mon Nov 19, 2007 10:49 am**

Do you have the knock sensor disabled? Have you tried datalogging to see what the error code says?

Posted: **Mon Nov 19, 2007 6:02 pm**

yes have disabled the knock sensor and have also ran hondalogger with no error codes showing am stumped

Posted: **Tue Nov 20, 2007 5:59 am**

Hello Simon I just registered here to see if I could find out anything but it seems your 1 step ahead of me :lol:

Posted: **Tue Nov 20, 2007 7:08 am**

yep as usual

Posted: **Tue Nov 20, 2007 3:10 pm**

Is the light on the interface box flashing or solid? Based on the fact that you have changed everything ecu and Hondata related and the problem still exists, it sounds like a wiring problem or problem with the cluster. Does the light go out at all or is it on whenever the key is on?

Posted: **Tue Nov 20, 2007 7:39 pm**

The light on the interface box is solid. The light goes out when the ignition is at number 2 then its constant when car is started and running.

Posted: **Wed Nov 21, 2007 10:34 am**

I'm asking about the Check engine light on the cluster

Posted: **Wed Nov 21, 2007 8:25 pm**

Yeah sorry thats what I was on about in the second sentence of that post.

The light goes out when the ignition is at number 2 then its constant when car is started and running.

Posted: **Fri Nov 23, 2007 8:51 pm**

I had a similar issue once... Turned out that the chip was not burned correctly. Do you get the same results when using the ostrich?

Posted: **Tue Dec 04, 2007 10:36 am**

Datalog and check to see what you have the shiftlight set to.

Posted: **Fri Jan 04, 2008 1:32 am**

The shift light wasn't installed

Posted: **Fri Jan 04, 2008 11:05 am**

not having a separate shiftlight installed has nothing to do with checking the settings I have suggested. Please check to see what you have the shiftlight set to. If it has been set below what your car idles at, the CEL will always be illuminated.

Posted: **Fri Jan 04, 2008 4:45 pm**

Just tap a wire between D6 and A4. The B16B don't have the vtec pressure switch.

Posted: **Fri Jan 04, 2008 5:19 pm**

marlborocars wrote:Just tap a wire between D6 and A4. The B16B don't have the vtec pressure switch.

why would you do that when you can just disable by checking a box in hondata?

Hondata

B16b Hondata S200 CEL ON

B16b Hondata S200 CEL ON