Hondata

When I purchased KPro and had it installed and Dyno Tuned at Church Automotive....; the version of K Manager that was used was 1.2.2.8 and the new version is 1.2.2.9.
Recently had to format my notebook that had the previous version of KManager loaded...
When I reloaded my programs... I did not have a copy of the previous version so I downloaded the present version...
Now when I try to read old datalogs or create a new datalog... The display doesnot read properly; which I am sure is due to the new version of KManager...
I cannot get a copy of my MAP (calibration) since it is retained by Church and I am not familiar enough with downloading the ECU MAP and then reloading it.... This is my daily driver.....

Anyone have copy of KManager 1.2.2.8 that you can send me..... ????

Thanks,

Charles

Just use the current 1.2.2.9 version and go to Online, Tools and download the calibration from your ecu. After it has been downloaded upload it to the ecu. THis will update the calibration. Make sure you then save the file to your laptop.